Our Blog

This article sets out the five settings that have to move together when the material changes, compares SUS304, SUS430 and SUS316L on what each demands from the line, and gives a changeover sequence.

This article works the arithmetic on a 10-tonne coil on a 1,250 mm mandrel, from pad pressure through anchor tension to the four checks a slab has to pass. It covers the site conditions.

The first sign of a worn roll set on an NC servo feeder is a feed length that needs a small correction every second shift, not a mark on the strip. This article sets out the three symptoms worth acting on...

Every coil change is a stop, and joining the coils removes most of it while introducing a weld that has to travel through a 3-in-1 decoiler straightener feeder and a progressive die unnoticed.

This guide takes one 1,300 mm enquiry and separates the scope decisions behind the gap: mandrel type, roll count, control class and the boundary that decides who pays for site work.

This article compares the three architectures that work — two complete lines, a shared decoiler and straightener with separate feed units, and a single 3-in-1 with a diverter — on cost, floor length, changeover and scrap.

This article builds an interval plan on three counters — running hours, coil changes and tonnes uncoiled — with checks at 250, 1,000 and 2,000 hours plus an annual alignment measurement.

This article breaks the project into five cost blocks, works the payback arithmetic on a 60-tonne press at 45 SPM, and lists five hidden costs that never appear on a quotation.

A misfeed on a 200 SPM line either stops at the die protection or cracks the die. This case study follows a real crash on an eight-station progressive die running 1.5 mm SPHC....

A five-task labor model for a coil line, worked through on a 200 SPM line running 1.2 mm SPCC across three shifts. It separates run tasks from setup tasks, prices the coil change and the die change separately.

A two-out die fed from a pre-slit two-strand coil doubles output on paper and creates a new set of setup problems on the floor. This is the six-step sequence from die to mandrel, the roll...

A 6-tonne coil parted at an uninspected butt weld 40% into the coil, and eleven seconds passed between the break and the line stop. This is what the hold-down arm, the loop interlock.

This article separates a pressure fault from a roll surface fault and from a control fault with a ten-minute test, compares the four pressure systems in common use, and lists the four conditions.